Changes by last author:
Changed:
|
|| [Start]|| [Questions ]|| [ Injector] || [Ignition] || [Triger] || [Display] || [Wbo2]|| [Config] || [Table] || [Wiring]|| [Tools] ||
---- |
|
Corrado g60 turbo
|| [Start]|| [Questions ]|| [ Injector] || [Ignition] || [Triger] || [Display] || [Wbo2]|| [Config] || [Table] || [Wiring] ||[Idle]|| [Tools] || |
| VEMS build instruktions [1] |
|
VW Passat
|| [Start]|| [Elektronic throttel]|| |
|
Audi S2
|| [Start]|| [Questions ]|| [ Injector] || [Ignition] || [Triger] || [Display] || [Wbo2]|| [Config] || [Table] || [Wiring] ||[Idle]|| [Tools] || |
|
VEMS build instruktions [2] |
|
*We are building the vems test board for easy set up and locate errors.
The I dear is to connect the vems test board in-between vems and the wire harness plug and play or use for test in the lab. 1: simulate 36-1 trigger 2: simulate 60-2 trigger 3 secondary trigger 4: four egt values fore calibrate temp. Toggle switch 5: led diode on all output 6: build in 2x100 ohm resister for calibrate wbo2 sensor 7: 2 rca connectors for simulate trigger input via laptop pc 8: detect Flyback errors *Question: haw can we detect Flyback errors ?? If you have any comments to the vems tester please leave a note, any suggest are welcome |
|
Regards Peter
---- |
