Corrado g60 turbo
| [Start] | [Questions ] | [ Injector] | [Ignition] | [Triger] | [Display] | [Wbo2] | [Config] | [Table] | [Wiring] | [Idle] | [Tools] |
VW Passat
| [Start] | [Elektronic throttel] |
Audi S2
| [Start] | [Questions ] | [ Injector] | [Ignition] | [Triger] | [Display] | [Wbo2] | [Config] | [Table] | [Wiring] | [Idle] | [Tools] |
27-08-2007
Triad to connect my trigger tester on EC36 pin 13 0-4V +- pulse and measured 0-4 V before R91 and +- 0,1V after R91
Is this correct ?
Measurements with exchange crank home trigger
Measurements with exchange crank home trigger
Added a 20K resistor (12..15k is better, sometimes 20k is too high)
Soldered JP7
Mounting the stepper chip
C103 replace with 1nF (only needed on certain boards from a given old batch, 2005 or so)
added 1uF cap in parallel with C40
R182 shorted
Made wire for the crankhome-VR trigger input (EC18 pin 12)
Connected JP 2 and JP 7 so the primary trigger goes where it needs to:
