| [ Start] | [Questions ] | [ Injector] | [Ignition] | [Trigger] | [Display] | [Wbo] | [Config] | [Table] | [Wiring] | [Idle] |
Can you update this page ? Trigger measurements and updated trigger config/notes should be on this page (not on main page, especially not in chronological order). Delete outdated info to make it possible to get overview of the uptodate setup.
We scoped the oe dwell time, and that is 3ms.
- I had by mistake made a wrong jumper, so the main trigger was set to Hall instead of VR
- a bad idea to feed negative voltage signal to the processor pin
- Now cranking 200 RPM (OK), without trigger error, juhuuu.
- actually, it idles OK
- but sometimes backfires during cranking?
Crank and camsensor signal scopeshot - looks OK. VR (LM1815 input) triggering on falling edge of the EC36/27 and EC18/12
Also measure DC voltage of both triggers (engine off, but ignition on).
- EC36/27 ... DC measurement: ... V (primtrig sensor: .... Ohm)
- EC18/12 ... DC measurement: ... V (sectrig sensor: .... Ohm)
link to trigger :
This subaru legacy is running the 6/7 trigger setup
as it seems no one have had this running with a VEMS yet, i hope to have some help setting this up,
I will, then document it,so it will be pnp for other users.
This is the current setting, copied from Wiki (InputTrigger/SubaruTrigger ?),
Firing order 1-3-2-4
primary_trigger=29
secondary_trigger=59
tooth_wheel=02
trigger_tooth=00
another_trigger_tooth=03
crank_minper=75
tooth_wheel_twidth1=00
tooth_wheel_twidth2=00
cam_sync_r_edge_phase=00
cam_sync_f_edge_phase=00
reset_engphase_after=04
toothrel_normal=01
toothrel_missing=F0