MembersPage/SteinOvePrestmo (2005-09-18 12:30:11)

My name is Stein Ove Prestmo (mk1_G on IRC).

I work as an Mechanical Engineer doing 2D and 3D drafts.


My plan is to add GenBoard/VerThree (V3.1) to my project car.

The car is a '83 VW Golf GTI [1] with an 1.8T 20V engine.

The car is at the moment under restauration and the engine is rebuilt. The engine is an '97 Audi A4 (Engine code: AEB). The original K03 turbo is changed for a K04-023 and exhaust manifold from an Audi S3 or TT 225hp.


Is the K03 => K04 stepup significant?

No, The K03 is rated to approx 210-230hp on my engine while the K04 should be able to give me between 260-300hp

Flow maps for [K03-2072] and [K04-0025] turbo. [More Flow maps here]


My setup will incorporate GenBoard/VerThree V3.1 with

- 4 Individual Coil On Plugs (dummy ignition)
- OEM 60-2 wheel on the crank. Pictures: [1] [2]
- Hall sensor on the camshaft (One window).
- VAG AIT [1]
- VAG water temp. (OEM combined sensor for EMS and Instrumet panel)
- VAG throttle body with built-in idle control InTake/ThrottlePlates/VAGElectronicThrottle Idle switch, Idle engine position TPS and main TPS (I hope to control the idle with PWM the signal to the idle engine)
- Two knock sensors (I know the V3.1 firmware don't support 2 sensors yet)
- Wideband lambda sensor.
- 4x 440cc/min fuel injectors (Ford SVO / Bosch high ohm)

MembersPage/SteinOvePrestmo/WiringPage


MembersPage/SteinOvePrestmo/MyNotes


MembersPage/SteinOvePrestmo/MyshoppingList


Contact info: prestms [at] hotmail [.] com