MembersPage/PeterJensentrigger (2006-03-16 04:43:08)
[Start] [Questions ] [ Injector] [Ignition] [Triger] [Display] [Wbo2] [Config] [Table]

Edge = rising

Type = multitooth

Filtering = Disabled

TDC after the trigger (vr sensor) deg =??

Number of teeth on the wheel = 35

36-1

Trigger tooth = 1

Number one tooth after the missing one

Next Trigger tooth = 18

Crank min period usec = 3000 (assuming a 4cyl that is 6000usec for a whole crank rotation, which is 10000 RPM), but set it lower to be sure.


360/36=10

trigger_setup.jpg

36-1_2vems.jpg

36-1.jpg

36-1_1.jpg

36-1_2.jpg

beslag_1.jpg

beslag_2.jpg

With this non-standard missing-tooth shape, the signal will be bigger aroudn the missing tooth, and R181 (factory-installed on v3.3 ; needs a small and clean tracecut surgery before v3.3) becomes important (min 100k, maybe 180k or higher). See InputTrigger/RunOut

I'd

It's very annoying if the system is near the operation edge, and sometime loses track. In any case, watch wheel-error (mlp01 first line) in case of any hazard.