Audi urS4 1992 with the AAN engine
My goal is for now:
- use all original sensors
- replace the MAF with a MAP
- replace the original Lambda with a WideBand
- make my own electrical loom/harness for the engine, using VAG OEM connectors and Econoseal connectors on the Vems.
- Make the engine run nice and good.
- make it work with COPs from 1998-2007 VAGs, 06B905115L
- Q: is that power-input ? (not logiclevel) ?
- A: they are logic-level, 5v (not sure if its postive (+) though)
- Guide for conversion from original POS/coil to COP here:
- http://www.bonnquattro.se/aan/18tCoilPackConversionInstructions.pdf
Next goal:
- switch exhaust header
- another turbo
- larger injectors
- another WasteGate
- switchable fuel maps
What I know:
- I will buy the assembled vems with econoseal connectors
- I need 5 logic outputs for the ignition, would like a 3+5 version
- The extra flyback 30v diode seems like a good choice
- I will buy a wideband lambda
- I will buy a EGT sensor
- I want the LED (4x20?)
- I want a special lambda display
- EGT and knock sensors(would like to use the stock knock sensors)
- onboard MAP sensor 400 kpa
- I will buy some econoseal connectors 18+36
- Primary trigger Is VR
- Secondary trigger would be "audi trigger"
What I dont know:
Q: Shall I order 2+6 version, what can I use the 2 high current outputs for ?
A: Lots of things. Relay, solenoid, NOS, ...
Q: How about firmware and sensors, do I need to compile something myself ?
A: no need to compile anything. See VemsTune
Q: I suppose I should choose PS2 connector as well
A: useful eg. for wheel-speed input (but we can connect PS2 clock signal to an unused pin as well