2006.09.13
I have install/enable Launch controle and Shift cut on my VW golf running VEMS V3.2 with firmware/MT 1.0.53 using input channel 6 and 7 (mcp3208 + two 10KOhm pullup).
I can not use the original shift-cut function. At least not with the type of gearshift/gearbox that's in my old VW Golf, it is very hard to shift gear from 1 to 2 as fast as from 2-3 and 3-4.
I think a function like the launch controle, with a soft rpm limiter that's on as long as clutch is down, is much better fore shift-cut. It would also make it posible to drive the car easely on road, for every day use or between stages in rallys, without disabling the function.
I am successfully useing the launch controle function fore shift-cut, but is then missing it fore launch.
I find the shift-cut function useless and hope very much it is chanced before spring (race start), but what is others experiences with this function? What do you think of it?
Old suggestions fore shift-cut:
- a "minimum rpm" (at the moment the clutch is pressed) so the shift-cut function is disabled when your not racing the car.
- I thing the is very much needed if this "time-based" 100% ignition-cutting is going to bee used.
- I haven't tryed using this much because it's very hard to make a smooth shift, most of the time it resulted in hard beaking or acc. Maybe with some training this would work fore 1/4 mile but at least it needs a "minimum rpm"!
- maybe a "max rpm" and "controle range (shared)" (soft rpm limiter) that's on as long as clutch is down, as a alternative to the "time-based" 100% ignition-cutting.
- I tryed using the launch control function as "shift-cut" by setting "launch control max rpm" ~500rpm under shift-point (shift-ligth). This works great with smooth and fast shifts (0,3-4ms) when shifting at shift-ligth.
HW setup
Two 5-10KOhm resistors (marked with red) must bee placed at R85 (ch.6) and at R86 (ch.7), to pull the inputs op to +5V (+5V = off).
From the holes (marked with blue, the top one is ch.7) you have to mount wires to some free pins on one of the Econoseal-III connectors.
Notes
- A 5.1V zener-diode migth also bee mounted on eatch input fore protection.. http://www.vems.hu/wiki/index.php?page=GenBoard%2FUnderDevelopment%2FDigitalInputs
- "SCL" (old) can also bee used fore launch input, that's JP1 pin 3. Pin 1 is "SDA" used fore ALS, and 2 and 4 is GND.
Here is the external wiring I'm planing.. a contact under the clutch, and one on the steeringwheel (or where i'll find it convenient) to activate launch-controle insted of shift-cut.
The shift-cut function is activated when you press the clutch unless you press the ekstra button while pressing the clutch. When the clutch has been pressed you can release the button and Launch-controle is activ insted of shift-cut until the clutch has been released one time.
