Current projects:

Audi S2 VEMS Genboard 3 installation

Audi S2 VEMS Round installation

If you edit and comment anything on this page, please state your NAME next to YOUR text. Please!

TODO:

* Scope VEMS round narrowband lambda output compared to original narrowband lambda.

* Connect RPM input to VEMS Round

* Test Mickes VEMSlogger realtime mode with VEMS Round

* Connect the missing inj3- and altitude sensor pins in harness extension.

Made larger hole in engine wall to get cabling for wbo2 through. Luckily some previous owner had already destroyed the AC so I ran the sensor through the same hole. I also noted that the engine runs pretty much lambda 1 all the time and leans out(!!) at high rpms. Crappy chip tuning.

2006-08-22

Welded another lambda bung into the downpipe not far from the original one.

2006-08-21

VEMS Round electrically connected to ignition. Tested WBO2 sensor and it heats up and shows ~20% oxygene in air.

2006-08-15

VEMS Round installation start. Removed the ventilation to cut some holes for the wires.

2006-07-05

The extension harness for the 3B box is next to completed.

2 wires missing that wasn't in the AAN wiring I used to build the harness.

2006-05-xx

Jesper has told me that the Peugeot went to the junkyard after another 20000km running on genboard 2.2. Rest in peace!