MembersPage/VasilisP/AcInput (2017-05-25 18:44:18)

Subpage of MembersPage/VasilisP


AC => mot55/pin41 => mcp3208/... analog input => fw configured to raise idle

This setup can increase the idle speed once AC clutch kicks in


So that my idle doesn't drop or stall.

Believe me i have messed around with idle IAC settings probably more than anyone else,and there are occasions where the idle still drops and stalls. So for that reason alone, i would like to make use of this feature which i believe to be very important for my car.

Yes, understood. Makes sense !


2) I would like to have the option for the AC feature from firmware 1.2.38

Protected analog input needed to connect the 12v signal from the air con compressor to be incorporated to the ecu in order to use the settings to control the idle.

Please write everything you can about YOUR (actual) EC10 pinout in the EC10 section on MembersPage/VasilisP/EvapOutput


Analog input verification

With 1kOhm resistor, see the bottom of [VT help]

View gauges: analog inputs raw group.


ECU serial number is : v3/10581

According to our records aan/10581 does NOT have

'''AC => mot55/pin41 => mcp3208/... analog input connected

You can connect the AC signal (mot55/pin41) to a protected mcp3208 input

after Analog input verification (see above)

Recommended simple $0.02 parts:

We can give more tailored advice if (as instructed) you write everything you can about YOUR (actual) EC10 pinout in the EC10 section on MembersPage/VasilisP/EvapOutput