Teppo Kalske from Finland, born 1972
I'm currently using VEMS on my daily driver Audi RS2 with 16x14 maps.
Just tested 1.1.9 firmware with auditrigger:
- Gets cam sync much faster when cranking than older version, very nice!
- When revving engine without load (neutral) gives trigger error around 6500 rpm
- When revving engine with load (2nd gear) gives trigger error around 4000 rpm
- after trigger error ignition stays off until revs are below 2000.
- base timing seems to be quite a bit different than with earlier firmware
---
Here is a dump and log from 1.1.9
Today it felt better than last time I tried it. Unfortunately I didn't have timing lamp available so I couldn't check base timing. Plenty of trouble due to lack of proper vemsv3.ini for this config and tables.
http://www.audiclub.fi/kalske/vems/119/
Yesterday I had plenty of trouble starting the engine when temp around -15°C.
Engine crank about nice, took bit of a while to get cam sync (1.0.53).
After getting sync engine tries to start (promises) but fails to start. Problem is that there seems to be a strange gap in ignition(?) when mode is changed from crank to running.
A: You have a Very High ignition advance from low RPM, (30+ degrees), also a very low cranking threshold rpm (300) and a low cranking advance
Set all three leftmost bins in the whole spark table to 15,9,25 and set a 15 degree cranking advance, 400 rpm threshold and try again //Emil
Some inertia is needed to get over it and with a cold engine it is a real problem.
I tried different crank and afterstart ignition and fueling settings, no luck.
Another problem is that ecu seems to do too much Air Den enrichment. If I tune fuel-Map when IAT is around 10°C, it has to be changed to leaner about 5% when IAT is below 0°C, and even more when IAT is -10°C. (With warm engine of course)
Log, dump and msq can be found here:
http://www.audiclub.fi/kalske/vems/
I need help for picking right sensor-files, these are the measured points:
CLT (audi 5cyl 20vt standard sensor):
-20°C 11000 Ohm
0°C 6000 Ohm
100°C 200 Ohm
IAT (audi 1.8T 20v sensor):
-40°C 80000 Ohm
20°C 2400 Ohm
130°C 100 Ohm