| MembersPage/Sascha |
JP Diaz VR6 Drag Golf
Basic Info:
- Current configuration
- Primary Trigger: VR + OEM 60-2 Wheel
- Cam sync: NO
- Injectors: 6x ID2000
- Ignition: 3x GM Wastespark coil packs
- TPS: Mustang
- CLT: OEM/Bosch
- IAT: OEM/Boscvh
- IAC: None
- Knock: No
- SD Card: Yes
Current FW: 1.2.11
Issues with lambda getting "stuck" at 0.83
Issue with lambda getting stuck when doing a power pull, issue started out of no where and consistently getting worse so the point that I can no longer read lambda under large loads.
Wiring has been checked, and re-checked... Sensor is new.
Sensor had a hard time to calibrate at the beginning (seemed like heater wasn't activating correctly all the time under calibration) I had to start/stop the calibration process a few times in order to get the O2 heater activated for free air cal. Seemed to read fine otherwise and is accurate under light loads @ idle.
Screen shot of log:
