BMW M3 1987
Triggerwheel
My car is now running fine since i made a new triggerwheel. =)
[This] is the new one. And [this] the old.
![[This]](http://www.vems.hu/files/SamuelLindkvist/triggerwheel/triggerwheel361.jpg){kind=link}
![[this]](http://www.vems.hu/files/SamuelLindkvist/triggerwheel/triggerwheel602.jpg){kind=link}
Alpha-N
Unfortunately AlphaN do not work anymore since i changed from Nov24 firmware to newer. For the moment i use MT1.0.36 but i can not drive the car because of this firmware problem.
I have wrote in this page MembersPage/SamuelLindkvist/AlphaN/
Cams: 292/292 with 12mm lift.
No plenum. Just four 15cm intaketrumpets straight in the air, so no good place to put vakumhoses.
Config and Tables
Will upload my config.txt as soon as possible.
Fuel setup
4cyl, 2300cc
300cc injectors (2.4ohm) Bosch 0280150355, 1 in each port
| cyl | inj | EC36pin # | h[0] # |
| 1 | A | 7 | 01 |
| 2 | F | 18 | 20 |
| 3 | G | 6 | 40 |
| 4 | H | 17 | 80 |
h[0]=20 80 40 01 00 00 00 00
h[1]=00 00 00 00 00 00 00 00
Ignition setup
Multi-tooth trigger wheel 36-1.
VR-sensor from FORD.
2 ign banks, firering a dual coil with 4 outputs (Wastefire)
| cyl | Driver | EC36pin # | h[2] # | mdh |
| 1+4 | 00 | 33 | 00 | mdh82 |
| 2+3 | 01 | 35 | 01 | mdh92 |
h[2]=00 01 00 01 00 01 00 01