BMW M50 Vanos.
- [configs], (since srl is not 107xx) but 13013
- appropriate vemscfg to start: http://vems.hu/download/v3/Motronic88/base_M50_vanos_1.2.31.vemscfg
- (of course lower req_fuel OK for big injectors)
- minor verification:
- h[2]=00 50 20 10 40 30 10 70
- so this ign sequence supports igndualout (00 and 10 are neighbors); 50 and 40 also; 20 and 30 also (6 cyl; 10 and 70 not used for ign).
- => seems correct (the small proto series srl=107xx required camsync, did NOT support igndualout) anything before and after supports;
misc2out_channel=72 (ignch7); (definitely NOT ignch3 ! Doublecheck this; we want main relay to get activated, not an ign transformer fuse blown;)
17/06/2016 - Jason
customer states 2 coils aren't operational after loading the file from download/v3/Motronic88...
I opened the brd file in Eagle, grabbed a connector to count pins. mot88 pin 23,24,25,50,51,52 are the coils according to both "M50-vanos-vs-s50b32.xls" and bmw_pinouts.xls (both in the downloads Motronic88 directory. Eagle has Drive07 -> mot88/23,
| BMW mot88 | description | v3_output (Eagle BRD verified) | baseM50vanos config | What it should be |
| 23 | ign cyl 4 | drive07 | drive05 | drive07 |
| 24 | ign cyl 6 | drive02 | drive01 | drive02 |
| 25 | ign cyl 5 | drive00 | drive03 | drive00 |
| 50 | ign cyl 1 | drive03 | drive00 | drive03 |
| 51 | ign cyl 2 | drive01 | drive02 | drive01 |
| 52 | ign cyl 3 | drive06 | drive04 | drive06 |
Interestingly, drive04 and drive05 are the channels the customer says doesn't work, which backs up the hardware findings. According the the brd file, drive04 goes to mot88/7 which is vanos solenoid on the m50vanos, and drive05 goes to mot88/27 which is the main relay activation.
So it appears our default config for m50vanos is bad in the ignition output area (at least.. that's where my focus has been so far).