TRACTION CONTROL STRATEGY
Car Audi a8 quattro 2.2 20VT 950hp
Vems 3.6
I need some strategy for a traction control when car starting some spark cut or slow reving by a specific time , or ignition retard for first gear, im need some specjal solution
A: It is possible to use per gear boost target, per gear ignition trim, anytrim (http://vems.hu/vt/help/v3/v3_anytrim_control.html) on slip ratio between front/rear wheels or launch time.
Any or a combination of these functions should provide proper off starting line response - DB
How I can reduce power on start only ?? in all of this option car always running on retard ignition on 1 or 2 gear or reduced boost or when im active launch time vs ignition retard i have retard ignition on each gear.
Im need some special conditions for launch setup some like no2 conditions , and strategy for holding rpm by specified time
0,1 sec on 4100 rpm
0,2 sec on 4300 rpm
0,3 sec on 4500 rpm
0,4 sec on 4900 rpm
etc...
In wheelspeed firmware by-speed launch-RPM limit is more reasonable and more commonly applied. Using by time is also possible:
- definitely in the PS2 firmware.
- I think even in wheelspeed firmware, anyttrim on launchtime (+ 50% tps) and trim launch rpm easy
- see: http://vems.hu/vt/help/v3/v3_anytrim_control.html for more details
Trigger Problem With hall sensor
i use this sensor and trigger wheel
sensor:
trigger wheel
and problem is with trigger errors i change in vems
SJ2 closed, SJ6 open
R30 pullup - install 4k7 resistor, and 2701 still problem
my config file
trigger log 4k7 resistor
trigger log 2701 resistor
photo inside ecu before SJ2 closed, SJ6 open
