MembersPage/KevinBlack/PorscheTurbo (2011-12-12 23:05:32)

Porsche 911 Turbo, engine unknown but had the Motronic from the 3.2 engine running before vems install.

Flywheel tooth and flywheel pin triggering, flywheel supposedly is 129+1.

I took a trigger log, but it only shows the primary trigger.

Trigger log: http://www.vems.hu/files/KevinBlack/v3.3_u004215-2011-12-10-17.14.37.triggerlog

The flywheel pin trigger is working (checked with scope for polarity)

trigger was set to missing tooth, is now set to coil type and

now I see an RPM signal, and I see "spark" in the trigger log.

ECU#4215 vr/vr trigger(auditrigger non camhall)

Tlywheel Tooth Trigger to EC36-27

Flywheel Pin Trigger to EC18-12

This engine is originally K-Jetronic (CIS), did you convert it to EFI? AFAIK 132+1 is present on 944 Turbo (240 mm clutch) but could be on 930 as well as it has also 240 mm clutch. 129+1 is not likely as it is for 225 mm clutches (911 3.2 Carrera, which has Motronic already).

Here's link to 911 Workshop Manual, years 1984-1989: http://www.cannell.co.uk/911_72-89_Workshop_Manuals/84-89%20Workshop%20Manual.pdf

Maybe there's some info on 911 Turbo as well.(MembersPage/PeepPaadam)

Porsche trigger config proposal:

http://www.vems.hu/files/KevinBlack/porsche_911.vemscfg


I tried a new set-up last night. The problem is, we discovered that the order is different each time we crank the engine.

Example: Checking Spark at #1 with a strobe light, first try we see the TDC mark, next try we see the 240 degree mark, next try maybe 120 mark.

The car actually ran for a while, I think it is just luck that it happened to fire correctly on that attempt.

Trigger Edge: Rising

TriggerType: Coil Type

Special Trigger Type: Auditrigger DivbyN

Audi trigger divider: 43

Number Of Teeth On Wheel: 6

First Trigger Tooth: 0

Next Trigger Tooth: 2

This set-up makes a clean triggerlog with 6 triggers and 6 spark events.

Logs will be posted later tonight. Thanks.