Acceleration enrichment
Q: Can anyone point me in the direction of help regarding acceleration enrichment?
A:*Dont worry about this,first try to get running the car through the whole RPM range.
- You must have a basic VE table first,Than you can play with the numbers (on a warm engine),and see when is it best.
- You floor the throttle,with the same speed for 4-5 times ,and see what happens on the WBo2. Im currently using 0.2s accel time. I tried different numbers in the rate / value fields,and a linearly increasing (from bottom to top) is what im currently using.
- oh yes ,and use TPS based accel enrichment!
- OK, done all of that.
I understand the concept of acceleration enrichment (sorting out transient lean spots when you stand on the accelerator), but I'm unsure how this translates into setting the parameters. Right now it's pretty good, but I'm only guessing at them and I know it's not quite right.
Q: Is there a handy description of the config parameters?
Current Config\n
tpsdot_kpadot_conf=00 tpsdotrate[0]=05 tpsdotrate[1]=14 tpsdotrate[2]=28 tpsdotrate[3]=4D tpsaq[0]=02 tpsaq[1]=04 tpsaq[2]=05 tpsaq[3]=0D tps_thresh=9A tpsasync=01 acmult=64 tpsacold=00 tpsdq=64
I assume tpsdotrate is the speed the accelerator pedal is pressed (4 levels) and tpsaq is the enrichment % to apply.
is the tpsasync some form of response time?
No idea what the others are...
All help appreciated!
Back to MembersPage/DavidBlades