Aim2Can analog inputs and 2 frequency (wheelspeed) signals are sent to v3.
6 analog inputs in full (12bit) resolution, and 6 in low resolution (4 bits, would be useful for ON/OFF activation)
v3 firmware (as of 1.2.43) only reads the 6 full-resolution analog channels, and stores them at the same place as analog input multiplexer (analog input multiplexer at the same time is NOT recommended, since behaviour is unspecified; If analog input multiplexer is used, only connect the v3 TX => RX of aim2can direction of the RS232 cable).
VT example to read 6 analog inputs (and possibly 2 wheelspeeds) from aim2can => VEMS v3 ECU (in this case, bidirectional RS232 necessary between V3 and aim2can, of course)
