Changes by last author:
Added:
VR,VR (m60b40 is VR/VR so no 3d trigger ! No VANOS at all.
* the NFETs are only for idle than. NFETs controlled from S259/1-2 are best for idle, (not "inverted p259", but either works) |
* Firing order 1-5-4-8-6-3-7-2 |
* Firing order 1-5-4-8-6-3-7-2
** notably cyl 1 and 6 are friends (opposite cyl), like in the 153624 ---- Ignition outputs - ign dualout capable. Bolded those different from M50-Vanos pinout * ign1,6 ignch0,1 tracecut * ign5,3 ignch6,7 tracecut * ign4,7 ignch2,3 wired * ign8,2 ignch4, 5 wired If v3 fw allows 7,0 to be igndualout neighbors (without inverting), than cyl6=ignch7 could be an option (only 2 tracecuts total, not 3; no big deal though). ---- Starting manufacturing from a spreadsheet similar to [S50B32] that clearly specifies EC36+18 - Mot88 mapping (with some ign remapping, respecting ign dualout compatibility) |
We can start manufacturing from a spreadsheet similar to [S50B32] that clearly specifies EC36+18 - Mot88 mapping, |
- secondary_trigger: HALL |
- secondary_trigger: VR (not HALL as in earlier order)
mot88/pin17 should be sectrig VR input (mot88/pin44 should be CAM GND) |
- Hi-side PFET outputs: 4 |
- Hi-side PFET outputs: 4 Actually 4 NFETs, not PFETs |
- Knock input channels: 0 |
- Knock input channels: 2 (not 0) |
- EGT input: 2 |
- EGT input: 0 .. 2 |
Other outputs |
Other outputs (generic note, not M60B40 specific) |
Notes |
NFET output
* mot88/pin2,29 are idle, NFET clearly best (does not matter if inverted or not) * mot88/1=FP relay (p259 or NFET should do, but not inverted if possible). * pin27=ECM RELAY CTRL ... ** isn't that a problem if inverted ? That means it turns on automatically at powerup (eg. if not configured, or firmware+config not running at all for some reason). ** for ECM or FP Relay it sucks if ON when not configured indeed, better redirect those control channels to S259 out 1/2 ** OK, so they best to be controlled from S259, not p259 inverted (even p259 is better than p259 inverted). That way relay only activated intentionally |
* need M60B40 units to have NFET outputs on P259 |
* need M60B40 units to have NFET outputs (on P259 or s259) |