* MembersPage/RicoZiemer

I want to buy VEMS and put it to my BWM E28 528i '84 with a M30B28 engine running L-Jetronic engine managment. I want to keep an original sensors, wires etc.

I have intention to order Assembled v3.3 controller in this setup:

* 1-wire interface: NO

* Flyback: 30V

* ignition driver: 0

** are you sure about this ??? 6 IGBTs allow you to use up to 6 power outputs, or upto 6 logiclevel (2 from i259 + 4 stepper outputs)

* Knock and EGT: YES (with second knock sensor input wire to

* EC18pin2)

* LCD connection: YES

* MAP connection: 400kPa (6/4mm pneumatic)

* mounting-style: NO-SCREWS

* PS2 connection: NO

* primary_trigger: VR

* secondary_trigger: AUDITRIGGER

I hope, that the configuration what I chose will allow me to trouble-free connect and start VEMS.

----

Trigger

To verify VR,

Please measure inputtrigger resistance of both sensors. Should be same (usually 400..1300 Ohm) in both directions.

* measured primary trigger resistance = ... FILL THIS IN

* measured secondary trigger resistance = ... FILL THIS IN

----

I need some help on my project, thank you.