There is a request (and intention) to implement Suzuki trigger (HALL-HALL, right ?) 36-2-2
Suzuki m16 Euro5 engine from 2012 trigger is
36-2-2 (=32 teeth total) :
- 10 teeth and 2 missing
- 22 teeth and 2 missing
Bottom pic is Euro4 Suzuki 36-2-2-2 , a known existing variant
(already fully supported, configlets available) MembersPage/SuzukiThirtySixMinusTwoMinusTwoMinusTwo
which has
- 13 teeth and 2 missing
- 16 teeth and 2 missing, 1 tooth and 2 missing
That is 30 teeth total, 36-2-2-2 as we usually call.
Mounts on the same crankshaft (orientation fixed by the drill at 3 degree) but it is a LOT of work to replace, (whole engine disassemble work)
TODO: exact details
If the trigger pattern is known exactly, by degree, it can be implemented
Primary trigger pattern
- IMPORTANT
- Fill in. Numerically
- photo or trigger pattern, triggerlog
- and/or reference, other evidence
Sectrig pattern, 4 groups (90deg = 180 crankdeg)
- pattern and relative position to primtrig is also important
- 1
- 1
- 2 teeth (appr 6..10 deg after or before?)
- 2 teeth (appr 6..10 deg apart or before ?)
It is possible to grind off teeth from the
Note: there was a reference to some email, but the email was not available or findable. Please add here. Thank you.