MembersPage/MercedesAmgM113/LcdPages

LCD page 4 was used. (number 4 is entered) See [VT help]

note: -D CUSTOMLCD (customlcd.h)
- RPM:0000 kPa:099 :Engine Speed, Mainifold Air pressure
- La:??.? EgoC:100 :Lambda, Ego correction
- Clt: 44C Air:-19 :Coolant temperature, Manifold Air temperature
- Egt:0000 Tps:76% :EGT temperature, Throttle position
Page 4 currently:
- RPM MAP
- lambda egocorr
- CLT MAT
- EGT TPS
wish:
- RPM MAP
- lambda Oiltemp
- CLT MAT
- EGT TPS
alternatively:
- CLT MAP
- MAT RPM
- Oiltemp lambda
- EGT TPS
Even better:
- CLT MAP
- MAT RPM
- Oiltemp lambda
- EGT TPS

My request would be this, if possible.

-CLT -MAP

-OIL TEMP (ch6) -LAMDA

-MAT -SPARK ANGLE

-EGT -KNOCK VALUE AVERAGE

lcd_line_40, lcd_line_41, lcd_line_42, lcd_line_43,
const lcd_line_40[] PROGMEM = { lcd_space, lcd_rpmstr, lcd_rpm_true_4char, lcd_2space, lcd_space, lcd_KPAstr, lcd_P, LINEEND1 };
const lcd_line_41[] PROGMEM = { lcd_2space,lcd_O2str, lcd_O2, lcd_2space, lcd_egocorr, LINEEND1 };
const lcd_line_42[] PROGMEM = { lcd_space, lcd_coolantstr, lcd_coolant, lcd_2space, lcd_space, lcd_AIRstr, lcd_T, LINEEND1 };
const lcd_line_43[] PROGMEM = { lcd_space, lcd_egtstr, lcd_egt1, lcd_2space,lcd_space, lcd_tpsstr,lcd_tps_percent, LINEEND1 };

TODO: Oil temperature instead of lcd_egocorr (not injector duty cycle)
- Oil temp is on mcp3208/6 analog input
TPS is also not very interesting.
EGT, lambda, RPM, MAP, MAT, Oil temperature, Coolant temp are extremely important

Note: some recommendations also on MembersPage/Hexer