Audi A6C4 1995 (1996) AAN engine installed in 2025 (Vizsgaztato Pityu)
Crankhome VR trigger see InputTrigger/AudiTrigger
Checked crankhome-VR with DSO138 scope. It was -peak first, than +peak, NOT good, had to be swapped as instructed on VemsAudiAan
- Swapped red and violet wires.
- Checked crankhome-VR again with DSO138 scope, not good: +peak first, -peak later.
The wires were good with red in middle (a bit contradicting the VemsAudiAan page but scope is always right.
- TODO: scopeshot
Engine started on first attempt.
- [1] log and config