VEMS Home Products Documentation Wiki Webstore
WikiHome ProjectPage DocsPage UnderDevelopment MembersPage SiteIndex RecentChanges Preferences
History of GenBoard/Manual/WideBandDualWboHardware
Older Newer
2025-06-06 17:43:58 . . . . c-24-147-75-39.hsd1.vt.comcast.net [v3tester was Jasons calibration problem]
2021-10-01 09:50:56 . . . . 88.119.113.145 [advice]
2021-09-30 21:58:49 . . . . 84-236-90-236.pool.digikabel.hu [sensor calibration]
2020-04-15 22:53:27 . . . . 88.119.113.145 [ec18-17]
2020-04-15 15:52:06 . . . . c-71-233-249-141.hsd1.vt.comcast.net [C26 didn't help]
2020-04-15 10:19:52 . . . . 88.119.113.145 [added link]
2020-04-14 13:09:34 . . . . c-71-233-249-141.hsd1.vt.comcast.net [Thanks for C26 thread.]
2020-04-12 10:56:29 . . . . 88.119.113.145 [some thoughts]
2020-04-11 17:47:52 . . . . c-71-233-249-141.hsd1.vt.comcast.net [Added link to config/log]
2020-04-06 09:10:26 . . . . 178-164-238-83.pool.digikabel.hu [link to dummy config]
2020-04-06 09:04:30 . . . . 178-164-238-83.pool.digikabel.hu [resistors on 1st WBO2 also]
2020-04-06 04:43:53 . . . . 178-164-238-83.pool.digikabel.hu [moved from other page. Minor cosmetics]

Changes by last author:

Added:
-------

Back to this issue again, and almost gave up, but finally pushed through the problem and found that in my case, everything was correct. The v3tester was causing the issue. I used an ec18 connector and two lsu4.9 connectors for WB1 and WB2, with a lsu4.9 male size "calibrator" that has the 100ohm test resistors. They both calibrate perfect. -Jason