#####  
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

 #       
 #       
 #   #   
 #  #    
 # #     
 ## #    
 #   #   
         

         
         
 ##  ##  
 ####### 
 ## # ## 
 ##   ## 
 ##   ## 
         

 _____ 
/  __ \
| /  \/
| |    
| \__/\
 \____/
       
       

         
         
 ### ##  
 #  #  # 
 #  #  # 
 #  #  # 
 #  #  # 
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
This will be a ongoing discussion on the build up of a new VEMS V3.3 and build of a wiring loom to handle a M20 or M30 engine in a BMW E30 series. - Loom will be able to handle a stock NA engine as well as a Forced induction setup along with boost control, wideband signal and EGT signal. Loom will be able to be installed into any E30 with a identical C101 plug (where the engine loom connects into the car). Install when loom is ready should take about 30-40minutes. More later.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.