####   
 ##  ##  
 ######  
 ##      
  #####  
         

         
         
  ####   
 #    #  
 #    #  
 #    #  
  ####   
         

 _______ 
/ ___   )
\/   )  |
    /   )
   /   / 
  /   /  
 /   (_/\
(_______/
         

 _       
| \    /\
|  \  / /
|  (_/ / 
|   _ (  
|  ( \ \ 
|  /  \ \
|_/    \/
         

         
         
  ### #  
 #   ##  
 #   ##  
  ### #  
      #  
      #  

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
---- http://www.vems.hu/files/MembersPage/PeterJensen/s2/trigger_135_ref.JPG http://www.vems.hu/files/MembersPage/PeterJensen/s2/trigger_135_ref_1.jpg ---- Added a 20K resistor (12..15k is better, sometimes 20k is too high) http://www.vems.hu/files/MembersPage/PeterJensen/audi_trigger/trigger_1.jpg Soldered JP7 http://www.vems.hu/files/MembersPage/PeterJensen/audi_trigger/trigger_2.jpg Mounting the stepper chip http://www.vems.hu/files/MembersPage/PeterJensen/audi_trigger/trigger_3.jpg C103 replace with 1nF (only needed on certain boards from a given old batch, 2005 or so) http://www.vems.hu/files/MembersPage/PeterJensen/audi_trigger/trigger_4.jpg added 1uF cap in parallel with C40 http://www.vems.hu/files/MembersPage/PeterJensen/audi_trigger/trigger_5.jpg R182 shorted http://www.vems.hu/files/MembersPage/PeterJensen/audi_trigger/trigger_6.jpg Made wire for the crankhome-VR trigger input (EC18 pin 12) http://www.vems.hu/files/MembersPage/PeterJensen/audi_trigger/trigger_7.jpg Connected JP 2 and JP 7 so the primary trigger goes where it needs to: http://www.vems.hu/files/MembersPage/PeterJensen/audi_trigger/trigger_8.jpg
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.