_    
    / \   
   / _ \  
  / ___ \ 
 /_/   \_\
          

  ____  
 / ___| 
 \___ \ 
  ___) |
 |____/ 
        

###      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
######   
         

    ##   
         
    ##   
    ##   
    ##   
    ##   
    ##   
  ###    

 _   _ 
( ) ( )
| | | |
| | | |
| (_) |
(_____)
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I reconfigured ignition outputs to wasted spark because I didnt get any voltage when I configured COPs as sequential. It is not clear how it was wired / configured in the 2 cases. Cylinder numbering and firing order are confirmed as correct. I would definitely write this down too. Don't expect anyone to review your setup without the basic information. Wiring is separate, i.e. every ign output is to one coil respectavely, also I wired separate +12v supply and grounds for them. * '''EXACTLY HOW''' ? Without camsync, some trick is needed to drive COP (eg. ign_dualout). The engine runs, but high dwell (3 .. 3.5 msec ?) was needed. * Im worried about the little voltage (almost none) from VEMS. ** what outputs ? ** what conditions ? ** what's connected ? ** measured how ?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.