###      
 ## ###  
 ## #    
 #####   
 ## ##   
 ##  ##  
#### ### 
         

  ____  
 |  _ \ 
 | | | |
 | |_| |
 |____/ 
        

 _______ 
(  ____ \
| (    \/
| |      
| | ____ 
| | \_  )
| (___) |
(_______)
         

         
     ##  
     ##  
  #####  
 ##  ##  
 ##  ##  
  #####  
         

         
         
 # ###   
 ##   #  
 #    #  
 #    #  
 #    #  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Hi. Need some help on building an plugnplay-ecu for an old 10v urquattro running a 25pin toshiba ecu. Its running the standard three sensor Auditrigger. Ive connected the Primary VR sensor to EC36/27. Should I connect the Hallsensor to EC36/13? Where on the board should i connect the Secondary VR sensor? http://vems.hu/files/ErikEnglund/pictures/urquattro_board.jpg Board Serialnr 3919 . Ordered with Auditrigger setup. Thanks for all your help! Ive come this far: http://vems.hu/files/ErikEnglund/pictures/urquattro_pnp.jpg Connect the sec VR trigger like this black and red wires http://www.vems.hu/files/ErikEnglund/pictures/Auditrigger_sec.jpg You may need a 1.5 kohm resister mounted on solder side at ends of wires. (Pull down) http://www.vems.hu/files/ErikEnglund/pictures/Auditrigger_R.jpg
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.