_____ / ____| | | | | | |____ \_____|
## ## ## ## ## ## #### ## ## ## ##
___ ( _`\ | (_(_) | _) | | (_)
___ ( _`\ | (_) ) | _ <' | (_) ) (____/'
_______ / ___ ) \/ ) | / ) / / / / / (_/\ (_______/
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: Audi A6C4 1995 (1996) AAN engine installed in 2025 (Vizsgaztato Pityu) ---- '''Crankhome VR''' trigger see TriggerScoping and InputTrigger/AudiTrigger Checked crankhome-VR with DSO138 scope. It was -peak first, than +peak, NOT good, had to be swapped as instructed on VemsAudiAan * '''Swapped red and violet wires.''' ** Checked crankhome-VR again with DSO138 scope, '''now good: +peak first, -peak later''' since LM1815 triggers on negative going zero crossing. http://www.vems.hu/files/MembersPage/Quattro/Audi_A6C4_AAN_2025_install/DSO138_Audi_AAN_20VT_crankhome_positive_peak_first_for_VEMS_ECU.jpg The wires were good with red in middle (maybe contradicting the VemsAudiAan page but scope is always right). http://www.vems.hu/files/MembersPage/PeterJensen/audi_trigger/stik_trigger_morm.jpg ---- '''Engine started on first attempt.''' Actually it was behaving, and powerful... But owner already contracted with some VEMS tuner (maybe Kulinpapa?) to tune it on 4-wheel dyno the next day. So we did not press it. But lambda was at least quite reasonable at high power also. * overrun fuelcut (when throttle is released, but engine RPM is still high and fuel is cut so engine goes to idle) could be somewhat smoother... ---- * [http://www.vems.hu/files/MembersPage/Quattro/Audi_A6C4_AAN_2025_install/v3.3_u021315-A-2025.04.24-15.53.LehetMenni1.zip log and config zip] with 1.2.38 firmware Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.