_    
    / \   
   / _ \  
  / ___ \ 
 /_/   \_\
          

   ___  
  / _ \ 
 | | | |
 | |_| |
  \__\_\
        

         
         
 ######  
    ##   
   ##    
  ##     
 ######  
         

 _     
| |    
| |    
| |    
| |____
\_____/
       
       

  _______ 
 |__   __|
    | |   
    | |   
    | |   
    |_|   
          
          

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''For VR sensor''' * '''VR input is needed''' * or [https://shop.vems.hu/catalog/hall-p-162.html VR => HALL adapter] and HALL input ---- For '''HALL sensor, HALL input is needed''' VR input will normally not work (or worse: might work unreliably) '''VR input expects the signal to go negative''' (as a VR sensor...) and HALL sensor signal is positive between 0V (or rather +0.2V in practice) and +4..5V (because of 2k7 pullup resistor to +5V ; this resistor is usually inside the ECU when it has HALL input, otherwise it must be right at the HALL sensor; ) Some trick/hack might be possible (not difficult, but not supported; it might work reliably or not depending on if the installer knows what he is doing ; measuring, scoping, etc... again: not supported) with 470 Ohm and 15..18k resistor divider to get negative signal from mainboard (eg. 15..18k from RS232 -9V available inside on LCD pinheader) theoretically this results in >3V and <-0.01V "square" signal that should be sensed by the VR input, but "your milage may vary"... (again: DISCLAIMER: if it works, fine, but no support for this) http://www.vems.hu/files/sensors/Trigger/stupidVR/HALLsensor_VoltageDivider_schematic.png ---- Please see '''[https://vems.hu/vt/help/main/error_reporting.html error reporting for Tech help]''' and create project page via MembersPage * for a '''VR sensor, measure the resistance of the sensor''' (measure resistance with DVM with the sensor disconnected from circuit), it should be '''same in both directions''' ** In addition to the above, '''if VR sensor resistance is NOT reported''' => it is assumed that it might not be a VR sensor, or it might be faulty, or that even the most simple basic measurement is not done (or lacking the cheap tools like DVM or knowledge to use it) => either of them makes technical discussion infeasible (a waste of time).
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.