_________
\__    _/
   )  (  
   |  |  
   |  |  
   |  |  
|\_)  )  
(____/   
         

 _______ 
(  ____ \
| (    \/
| |      
| | ____ 
| | \_  )
| (___) |
(_______)
         

 _   _ 
| | | |
| |_| |
|  _  |
| | | |
\_| |_/
       
       

 _______ 
(_____  )
     /'/'
   /'/'  
 /'/'___ 
(_______)
         
         

 _______ 
(  ___  )
| (   ) |
| (___) |
|  ___  |
| (   ) |
| )   ( |
|/     \|
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
[http://megasquirtavr.sourceforge.net/manual/Basics.Install.Mechanic.html [Manual: Basics.Install.Mechanic]] Soldering steps of the mintest: * o Ohm resistor on the bottom * R154 under the atmega * LCD capacitor (C89) * Big troughole diode * quartz 16 Mhz * connect the GND-s * pinheaders for the ISP * do the firmware things and checks Soldering steps after the mintest: * big black barrell inductivity * knock chip * quartz 4 Mhz * main fuse wire * stepper chip * stepper capacitor (C75) * stepper Vbatt wire in the place of D45 * two trigger zeners (D14, D27) * trigger1 pullup resistor REMOVE (R55) * configure the trigger1 to VR, and the trigger2 to HALL * flyback diodes * wire out the knock the RS232 and the MAP signals into the EC18 * FETs,IGBT, EC connectors Back to GenBoard/Manual
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.