##  ##  
 ##  ##  
 ##  ##  
  ####   
   ##    
         

  ______
 |___  /
    / / 
   / /  
  / /__ 
 /_____|
        
        

 ___   
(  _`\ 
| ( (_)
| |___ 
| (_, )
(____/'
       
       

     ##  
         
    ###  
     ##  
     ##  
 ##  ##  
 ##  ##  
  ####   

   ___  
  / _ \ 
 | | | |
 | |_| |
  \___/ 
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Aim2Can analog inputs and 2 frequency (wheelspeed) signals are sent to v3. 6 analog inputs in full (12bit) resolution, and 6 in low resolution (4 bits, would be useful for ON/OFF activation) v3 firmware (as of 1.2.43) only '''reads the 6 full-resolution analog channels, and stores them at the same place as analog input multiplexer''' (analog input multiplexer at the same time is NOT recommended, since behaviour is unspecified; If analog input multiplexer is used, only connect the v3 TX => RX of aim2can direction of the RS232 cable). ---- '''VT example to read 6 analog inputs (and possibly 2 wheelspeeds) from aim2can => VEMS v3 ECU''' (in this case, bidirectional RS232 necessary between V3 and aim2can, of course) http://vems.hu/files/AIM2CAN/VT/aim2can_analog_inputs_sent_to_v3_VT_settings.jpg
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.