MembersPage/RobinJohansson (2006-03-16 04:43:08)

Volvo 244 -82

my_car.JPG

4 cyl, 16v, B234 block filled and O-ringed, forged pistons from ford probe 2.3L, forged H-profile rods, A cheap Super T70 turbo with Semi ballbearings, 60.5mm compressor inlet, 0.84 exhaust,

WB lamda, GM 3bar map sensor, 4*960cc injectors, 44mm wastgate, own manifold, own exhaust manifold, lage truck intercooler and

VEMS v3.1 board with serial number: 1st bord: 87 (2nd 99)

BMW 535 (getrag 260) gearbox converted to fit volvo.


Page TODO

Keep a clean page!


Current working on

get it running...

Valued tip

Back to tabletests: apply lightbulbs or LEDs on outputs, and see OnlineCourse/OffEngineTesting mst63 msp01 (or up to msp7E for lowest RPM) can be used to generate stimulator-output on (stolen) config.act_wot_channel output that can be fed back to self (primary trigger) or to another board - with a series cap if LM1815 is used.


Trigger wheel

trigger.JPG

Bosch VR sensor (jetronic), 36-1, mounted at crank.

Trigger wheel is a castiron, 36-1 with a teethwide of 4mm->4.5deg and 5mm~>5.5deg jumps, missing tooth 14mm~>15.5deg


Fuel setup

cyl inj EC36pin # h[0] #
1 A 7 01
2 F 18 20
3 G 6 40
4 H 17 80

h[0]=80 40 20 01 00 00 00 00

h[1]=00 00 00 00 00 00 00 00


Ignition setup

2 ign banks, firering a Ford dual coil with 4 outputs (Wastefire)

cyl Driver EC36pin # h[2] #
1+4 06 24 06
2+3 05 12 05

h[2]=06 05 06 05 00 00 00 00


Updated 2005-08-01

My tables

http://www.vems.hu/files/RobinJohansson/tables.txt

My config

http://www.vems.hu/files/RobinJohansson/config.txt


My V3.1 board:

robin%20v3.1%20out.JPG