Hello! This a very interesting mini car, that 12-1 primer trigger it would like to be used, with hall sensor the crankshaft. There are three cylinder engine, which 120 use pushed away in a degree, in the car. The spark is coil on plug.

This is not a good setup. Each coil fires twice, will damage sooner.

Next trigger tooth=4

Trigger tooth=0..3

tooth_width is 30 degrees, (120=0x78)

reset engphase after= does not matter, set to 160

Hello! The car started, and works fairly. The correct settings are here:ó.msq