Want to do a PnP install on my Mazda 323 GT-R but also on some Group H Rallye Cars.
Hardware is 90% done.
Sotware is 20% done.
Specs:
Engine:
- 4cyl
- 1800ccm
- 440cc Injecotors
Ignition:
- Single Coil + Distributor
- Ignition Module (using Logic-Level Output)
Trigger:
- 4+1 Cam Sensor
Sensors:
- Flap type AFM
- TPS
EMS:
- Genboard 3.5
- Firmware 1.1.50 (downgrading to 1.1.27 until engine runs perfect)
Progress:
Hardware:
- Genboard installed in factory ECU case
- installed additional 9pin connector for IAT, MAP and WBO2
- MAP/AFM, IAT and NBO2/WBO2 swichtable
- WBO2 and MAP sensor have been already installed in car for a ZEITRONIX WBO2 Display
- built a trigger emulator with mega8 uC for testing
TODO:
- install EGT
- check if factory knock can be used with vems
- intall wasted spark ignition coil
Software:
- Measured Trigger with Scopemeter
- Measured ignition timing of factory ECU
- Measured injector pulse witdh of factory ecu
- Engine starts and runs but very badly
TODO:
- Get engine running stable with AFM
- Get engine running with MAP sensor
- Values for warmup and acceleration enrichment doesen't work good
- Get WBO2 working
- Get wasted spark ignition working
- Boost control when using MAP Sensor
- ALS/Launch Control
Information:
Trigger:
Same Trigger as on [MembersPage/Fero] but i measured angles with scopemeter and got this values:
