Navigation
- Main MembersPage/KoabiBrooks
- Ignition MembersPage/KoabiBrooks/Ignition
- Injection MembersPage/KoabiBrooks/Injection
- Wiring MembersPage/KoabiBrooks/Wiring
- Q&A MembersPage/KoabiBrooks/Questions
WIRING PAGE
Current wiring notes (note, connector names from bentley manual):
- T2f (black connector by master cyl) R/Y should be fed to VEMS FP output
- PIN 15 on EC36
- T2f (black connector by master cyl) R/W should be fed to O2 sensor heater AND fuel injector power supply
- pin 3 on LS4U is heater supply
- Is running injection supply off of this source also going to be too much?
- Who knows! add 10a inline fuse if this ends up being supply for o2 and injection
- T3d (white connector by master cyl) black should feed VEMS +12v
- Pin 25 on EC36
Note: coolant bottle is removed for viewing.
Close up
- The top connector is a 2 pin mystery connector.
- Green and violet/black on the engine harness side (left).
- Green and blue on the main harness side (right).
- Green was for #50 starter trigger. Digifant needed it, VEMS doesn't.
- The middle connector is T3d per the Bentley manual in the 16v engine section.
- black on engine harness side and engine harness side
- Switched +12v
- Two wires from one pin, one wire from another pin on engine side (left)
- One loopback on main harness side (right) to power additional pin
- Red/black on engine harness side and main harness side
- This is off the starter relay...it's only powered when the starter is cranking...
- black on engine harness side and engine harness side
- The bottom 2 pin connector is T2f (the black connector)
- Red/yellow on both sidse
- From fuel pump relay output - route to ECU to allow priming.
- Red/White
- +12v switched that originally powered O2...will be used for that again.
- Red/yellow on both sidse
VEMS Harness
Here I will try to describe the harness I am creating.
WIRES - Greens are ground
- WBo2
- Red for +12v
- Yellow, blue, black, white for rest
- Members/PhatBob has a layout of the wbO2 plug
- Coolant Temperature Sensor
- Orange
- Green
- Intake Air Temperature Sensor
- Grayblue
- Green
- Throttle Position Sensor
- Yellow for +5v
- Pink for ECU input
- Green
- Need to find plug layout
- Wasted Spark Coil
- Red for +12v
- dark gray coil driver 00
- light gray coil driver 01
- ground (if pin 4 is really a ground) so need to find plug layout
- Crank Position Sensor
- Purple
- Green
- Fast Idle
- Red for +12v
- Beige to ECU
- VW ISV have 3 pins. gotta figure that out.
- Fuel injectors
- Red for +12v all the way through flyback
- black - injector driver A
- blue - injector driver B
- white - injector driver C
- yellow - injector driver D
- ECU
- Red for +12v
- Black for ground