Due to some interfering issues I left this page and the project aside for a while. Next is a new project:
BMW E12 M30B35 engine from an E34 '88 currently controlled with standard motronic and running great. However I want more control and learn more about engine management systems.
I installed a vaporized injection LPG system with Keihin injectors based on a master slave principle. Hence my interest in the new firmware release with dual mapping capabilities.
To be updated/removed:
[\ MembersPage/JanSaenen/Links Links]
[\ MembersPage/JanSaenen/Buylist Buylist]
[\ MembersPage/JanSaenen/Vapourised Injection]
[\ MembersPage/JanSaenen/Progress]
[\ MembersPage/JanSaenen/Config]
EGT
My GenBoard (preassembled serialNr=355)
MegaTune will log both mcp3208channel4 and mcp3208channel3 (raw values). However, only mcp3208channel4 is displayed on LCD page0 (mlp00).
Raw values mean that the
- real_celsius_value = egt1_offs + (raw_value * egt1_cal / 256) where typical values:
- egt1_offs=00
- egt1_cal=49 (that is decimal 73)
Fuses
These are commonly used :
| Current consumer | Fuse rate | 'Description/Comment |
| VEMS Genboard | 3A | It actually draws a couple of hundre mA, but this is the smallest automotive fuse commonly found in gas stations |
| Lambda | 5A | |
| Injectors | 10A | This could be the main fuse, and a separate 3A fuse for each injector for safety if you get a short in an injector you could fry the driver with only one main fuse |
| Ignition coil | 10A | Possibly even higher, depending on the coil primary resistance |