The car is a Kadett C with a Calibra 2,0 16V C20XE engine mounted.
2006.09.13
The engine has a 60-2 trigger wheel on crank so I tryed to trigger the board with the signal-generator generating a 60-2 signal (m582 1740 200 20 1000 1000) but MT shows "trigger-errors", and a datalog shows random 0RPM one or two times every second.
http://www.vems.hu/files/HansK/datalog200609122217_trigger_errors.xls
I'm using firmware/MT 1.0.53
2006.09.19
I have tryed changing threshold on LM1815 with out luck. I'd like to try useing the board to generate the trigger-signal but I need firmware V1.0.53 where MY_CONF += -D WOT_OUTPUT_TPS_THRESHOLD is enabled in the my-make file.
my_make file, changed but not compiled: http://www.vems.hu/files/HansK/my_make.zip
Config:
primary_trigger=01 #toothed wheel and VR sensor
secondary_trigger=02 #disabled
tooth_wheel=3A #58 teeth (60-2)
trigger_tooth=10 #should it bee 02? explanation..?
another_trigger_tooth=1E
crank_minper=50
tooth_wheel_twidth1=6
tooth_wheel_twidth2=12
cam_sync_r_edge_phase=FF
cam_sync_f_edge_phase=FF
reset_engphase_after=FF #?
ign_tdcdelay=9A
ign_dwell14=3E
ign_dwell6=60
ign_crank_advance=50
ign_out=70
ignchmax=01 # waste sparke