Hi,
My projectcar is a 205 GTI with a 1.9 litre 8 valve engine. I turbocharged it some time ago and am now fully rebuilding/upgrading the engine to suit high boost. Have a look at my project webpage http://www.205turbo.nl
I;m looking into VEMS because I think it more advanced than the megasquirt i'm running now.
---
specs in a nutshell:
alloy 1905 CC wetliner engine
16 valve cyl head
Mitsu td05 16g turbo
--- update 18-08-05
Ok, got the vems all wired up. Everything seems to respond ok. Put in the 023 with megatune firmware version. (And used Dave Bruls' config files with small modifications.) And also megatune seems to work fine.
Will try to start the car one of these days.
- Only problem is the volt meter in Megatune. It gives 20 volt readings while battery voltage is 13 v.
- You probably missed to calibrate it, adjust battery calibration. Default batt_cal=0xBC (decimal 188) or so
- thanks for that!
- You probably missed to calibrate it, adjust battery calibration. Default batt_cal=0xBC (decimal 188) or so
Ok things are getting along quite nicely.
The engine turns.
I get an RPM sgignal
There is fuel coming out of the injectors
but still no spark. will have to look depper into that. Running wasted spark. (bosch coil) there is +12v on the ignition drivers (00 and 01) but it seems they do nog get switched.
put the folowing line in tables.txt
h[2]=00 01 00 00 00 00 00 00
these are in the config.txt:
ignchmax=01
filled the ignition table
set the ignition settings as followes:
ignition outputs: 01..00
ignition driver type: DUMMY
ivert driver output Disabled
chargetime @ 14v 3.46
chargetime add @ 6v 4.18
set the trigger seetings as follows:
edge: rising
type: multitooth
Filtering: disabled
TDC after the trigger (deg): 62.0
number of teeth on wheel: 58
trigger tooth: 8
next trigger tooth: 30
Cranck min.period: 1280
angular with of tooth: 6
angular with of missing tooth: 18.
But I assume that to be quite ok because the RPM shows up (or is that a wrong conclusion)
set crancking advance to 20.00 degrees
Problem is there is no spark at all.
Checked the + to the coil (up to the vems) and seems ok.
Anny suggestions to where top start trouble shooting would be welcome.