MembersPage/FredrikHafslund/InputTrigger (2006-03-16 04:43:08)

The triggerpart of my config file

Using a wav file for table-testing, recorded from the engine that is in the car now.

Will use stock triggers (VR/VR).\n

#############################################################
#
# Triggers, HW determines VR or Hall
# software defines how it reacts
# 
#
# ========== 60-2 Trigger Configration ====================
#
# ======Primary_Trigger ====================
#       FE:           Rising Edge trigger
#       FF:           Falling Edge trigger
#       01:           Multi-tooth configuration

primary_trigger=01   # Multi-Tooth configuration

# tooth_wheel:
# Used for multi-tooth wheels
# Total number of teeth
# eg For 60-2 wheel, 58 teeth between the missing tooth = 3A
# eg For 36-1 wheel, 35 teeth between the missing tooth = 23 

tooth_wheel=3A     

# tooth_wheel_twidth1:
# width (in degrees) of each tooth 
# eg For 36-1 wheel, each tooth is 10 degrees = A

tooth_wheel_twidth1=6

# trigger_tooth:
# Used for multi-tooth wheels (Tooth that triggers event)
# so that trigger tooth is ~60 degrees BTDC

trigger_tooth=00   # so that trigger tooth is ~60 degrees BTDC

cam_sync_r_edge_phase = 141 (dec)

# ======Secondary_Trigger ====================
#       FE:           Rising Edge trigger
#       FF:           Falling Edge trigger
#       01:           Multi-tooth configuration
#       ??:           Cam Sync setup?

# FF = disable, even prevents inj and ign firing
# 02 = disable, but allow inj and ign firing
# http://www.vems.hu/wiki/index.php?page=GenBoard%2FUnderDevelopment%2FFirmwareChanges
# please help identify/kill bad recommendations about this found anywhere

For every parameter, global.h is the primary place for the meaning of variables. secondary_trigger is no exception. Document the

on a page (make sure to organize thematically not chronologically) like MembersPage/FredrikHafslund/InputTrigger so we can help you with your config.\n

secondary_trigger=02
cam_sync_r_edge_phase=FF
cam_sync_f_edge_phase=FF
reset_engphase_after=FF			

# another_trigger_tooth: decimal 20 is used for 60-2 toothwheel and 6 cylinder (3 events per crankrot)
another_trigger_tooth=14

# not used without camsync
tooth_wheel_twidth2=12