MembersPage/FPhil/Install (2011-09-02 21:59:24)

I made a cradle to install Vems under the dashboard. This is not too far from the ignition and injection ecu from where I would get the signal sensors.

This picture would only see something to someone who already knows the car ;) I set the Vems under the dashboard

install1.jpg

Noise from Vems

Next I made the harness between injection ecu Mplex and Vems following the documentation instruction concerning the "grounds";

Everything is coming from Mplex (ground, 12V etc) through and 8 poinst external connector: triggers signal is one wire shield on the Vems side

Then I bench test it.

To debate ..

- I conclude that there is a noise radiated by the multiple ground wires coming out the genboard the more wires, the more noise)

- that it is better not to shield the trigger on Vems side

- besides I do not understand much the physics or the maths of the recommendation: "all 4 GND5 (power-ground) pins must be connected to GND (EC36pin26) with short wires max 40cm (1.3 feet) from EC36 connetor to avoid damage caused by GND5 voltage jumping too high above GND (when ignition transformers, injectors or other loads are driven) ..." from "GenBoard/Manual/GroundConnections .

Why not make a hard connect Ground 5,32,21,22 (good section). (This will save some pins) ??

VemsWire2.jpg

The Mplex electronics and the MPlex case are together grounded to the battery through the car hardness and to the car body through the case.

First firing

For the first start I kept the injection ecu of the car (IAW) and I subtitute Mplex with Vems. So set the Vems ignition to drive only 2 pins, one to fire banK A the other to fire bank B from the 2 coil through the distributor.

The engine started at first try Hurrah !

There is picture wich only shows the 2 wires from Vems to the coils! Nothing spectacular !

install2.jpg

It takes more about one and half turn to start, too much for my taste

Q: Are there some settings to tune? Advance Filtering for the crank trigger