Ignition Introduction
As a starting point, I tried to use Alien logging via the secondary trigger to learn what the dizzy actually does. This wasn't very successful due to a couple of factors...
- Alien logging was broken in the firmware I am using. I got something working, but I don't trust it all that much...
- The vac advance on the TVR distributor is not all that sensible - it has a delay in it, meaning that a given RPM and manifold pressure is not enough to say what the total advance should be.
| RPM | 1000 | 2000 | 3000 | 4000 | 5000 | 6000 |
| Advance | 8 | 14 | 20 | 26 | 27 | 28 |
I do have an approximate ignition map from this, based purely on RPM which will do to start with. I will then apply "vac advance" as required during mapping. The new scheme should prove much more successful than the original system. (I will eventually get the car to do more than 20 miles to the gallon on local roads, even if I have to push it!!)
First cut ignition map
[Add table]
Ignition Hardware and Wiring
I have ordered 8 coilpacks from http://www.034motorsport.com/ in the USA.
Possibly worth thinking about stocking them in the webshop for those of us who don't have coilpacks in the car as standard? Even with tax and stuff paid, they should only cost 50 euros or so. (Maybe less if they're bulk ordered.)
The first job is to get some brackets made up to support the coils. They will be placed on the left hand rocker cover, as this is the only flat space I have left in the engine bay! (The right hand side will be used for the twin throttlebody plenum)
Coils test assembled:
I hope to get the brackets machined from aluminium this week.
This didn't happen, so I had to resort to plan B - making them out of what I could buy from the local DIY store.
Brackets on the engine:
It won't look too bad when all the wires are arranged neatly.
Coil Polarity
There is a turret for the HT lead and a 3 pin connector on the coil. The 3 pin connector contains ground for the secondary and both the primary connections.
No wiring instructions were supplied, so coil polarity will be worked out by either guessuing or applying a step change of voltage to the secondary and seeing which way the primary voltage moves... It does make a difference if the polarities are correct - the centre of the plug electrode should be +ve wrt the engine block. Q Is this correct?
Yes, spark polarity matters. I didn't found the article I read this so
- google: positive spark polarity ground engine sparkplug
- a [snippet]: the breakdown voltage is increased by about 30% for the plug with the positive polarity on the center electrode. What does this mean? One, our ignition system has to be able to come up with this extra juice, and two, on two cylinders your center electrodes will show wear while the other two will show it on the ground strap
The supplier has sorted out the polarity for me with the aid of a nice diagram... All done now.
Back to MembersPage/DavidBlades