Hello, I have some problems here whit the Cam control!
It is a BMW V8, 4.4 Vanos engine.
It have a custom 60-2 wheel on the crank, and the std vanos trigger whell on the intake cams.
Everty thing is fine until i use the cam controle.
When the car starts moving the cam, i get trigger errors!
I have an idea that I have misconfig the trigger settings.
I have uploaded a triggerlog and a config file here:
http://www.vems.hu/files/Racezone/BmwV8vanos/seq%20trigger.vemscfg
http://www.vems.hu/files/Racezone/BmwV8vanos/triggerlog.triggerlog
Any ideas ?
Thanks for your time!
Regards Daniel
Hello Daniel,
Could you provide me with a triggerlog of engine cranking 8-10 seconds without inj and ign fuse ? Your current triggerlog (at engine running) does not provide enough resolution for proper review. Thanks!
Best regards, Dave
Hello Dave, and thanks for your time. Here is a triggerlog of 10 sec of cranking :)
http://www.vems.hu/files/Racezone/BmwV8vanos/cranking.triggerlog
Regards Daniel
Hello Daniel,
I have reviewed your triggerlog, good format; awesome!
proposed primary trigger settings:
- RPM filter, cam based trigger: disabled
proposed secondary trigger settings:
- delayed reenable filtering: disabled
- ignore sectrig pulses above: 255
- maximum primary edge between secondary edges: 20 (sync on the smallest window)
After applying these your engine should run without trigger errors, if there are any issues please provide another trigger cranking (same format).
Best regards, Dave