MembersPage/BillHart (2006-11-13 15:22:46)

Open Issues ToDo

Q: Has anyone experienced problems with either the kpa index or table look up that provides radically different VE returns depending upon if you approach the cell's kpa value from the high side or the low side? I can actually use a poteniameter to simulate a MAP sensor, set my rpm input on 5000 and approach a 90 KPA cell site from below and get one VE and from above and get a radically different one. Thanks, Bill

Here is some more information. You can see by http://www.lolachampcar.com/images/VE%20Lookup%20Problem.pdf that VE is changing radically with but a small change in RPM. The VE table that fed the above data can be seen at http://www.lolachampcar.com/images/Ve%20lookup%20problem%20ve%20table.pdf. I believe the firmware is picking the indexs when rpm is above 5000 and thus defining the four VE cell values to use. Then it is using the below 5000 rpm number when it does the actual weighting. This would tend to weight the VE towards the higher cell (as it would finding 4999's location between 4500 and 5000) while using the VE value pulled from a 5003 rpm reading. In short, the input to the lookup function is not time aligned such that the four VE values from one point in time are being weighted by data from another point in time. When the data oscilates around a cell, bad things happen. Has anyone seen this problem before and is it something you guys are concerned about? Thanks, Bill

An example of how CWL, CWH, AWEV, AWEV_Temp..., and AWC affect cranking and afterstart can be found at MembersPage/BillHart/CrankingAfterStart.

Recent Questions:

MembersPage/BillHart/ProblemHistory for older issues that have been resolved.

Projects Underway

MembersPage/BillHart/WinMobileLogger Win Mobile platform to Fat32 memory card logger. Looking for SIPR examples, if any, to ease the adding V3.3 query to Win Mobile code.

MembersPage/BillHart/LoggingDongle anyone interested in a small relatively inexpensive logging dongle?