IssueReports/VemsTune (2010-09-02 00:52:16)

In case of bug reports please do not forget to write

  • I have the same problem(0.9.85)

An installer says: "When a customer has problems I like to be able to send finished mtt files to him, these can then be sent with command line tools or if he has communication problems I help him with bray over the phone"

Finished files make a lot of sense. It was planned that one would send project file, where the RIGHT firmware and/or config can be uploaded with 1..2 clicks (not lost in menu-s).

Note that the vemstune over the network will be very useful in many cases, but dealers still need a way to prepare project / vemscfg files (in a documented way!) that can be uploaded extremely quickly (without using menu-s) by a computer-illiterate child supported over the phone.


Gauges


Firmware Version

How do I get 1.0.79 to work with the current version VemsTune?


VT version 2010-07-08 + 1.1.78 FW:


VT version 2010-07-08 + 1.1.74 FW

normal_vetune.JPG

VT version 2010-07-16


VT version 2010-07-19

Analyze Trigger-Log consumed way too much processor and did not work on slower-CPU notebooks. From 2010-08-06, now it doesn't use excessive CPU and useful even with Nx100 MHz slow hosts too.

VT version 2010-07-19

fw:1.1.70, when i wanted to erase the sd card (tools/sd card log/erase) vt crashed. After erasing the sd with on older VT, start, stop, extended overview functions are work.


VT version 2010-08-19

It is impossible to remap MAT/TPS enrichment table with MAT values below zero. X axis negative values are incrasing every time I reopen MAT/TPS table. (fw 1.1.75, 1.1.80, 1.1.81)