IssueReports/VemsTune (2010-04-13 17:57:31)

In case of bug reports please do not forget to write

Issues

Enhanced ergonomics:

Can you give a more detailed info of the scenario

I would still like to maintain functionality with MegaLogViewer MSQ importing for auto VE calculation.


  • I have the same problem(0.9.85)

Upload stuff without using any menu-s

An installer says: "When a customer has problems I like to be able to send finished mtt files to him, these can then be sent with command line tools or if he has communication problems I help him with bray over the phone"

Finished files make a lot of sense. It was planned that one would send project file, where the RIGHT firmware and/or config can be uploaded with 1..2 clicks (not lost in menu-s).

Note that the vemstune over the network will be very useful in many cases, but dealers still need a way to prepare project / vemscfg files (in a documented way!) that can be uploaded extremely quickly (without using menu-s) by a computer-illiterate child supported over the phone.


- At the moment there is no way of just loading a project and start editing the "empty" config and then saving it to a file. It should at least have a Save as.. function so you can actually select to wich file to save the config. I´m talking about setting up a .vemscfg just like you can a .msq from scratch without connecting to a ecu at all. I don´t have a vemscfg cause I can´t save one from scratch and I don´t have a ecu to "download" one. - Gunni -


Gauges


Firmware Version

How do I get 1.0.79 to work with the current version VemsTune?


11/11/09

Vemstune 21/10/09 produces a kpa vs kpa table on the boost vs rpm curve.i use firmware version 1.1.62

Somehow one or two users have managed to fix that by installing and reinstalling vemstune on their computer. I must say i havent managed to get that fixed.

vemstune version 2/10/09 works normaly, but as soon as you put 21/10/09 it goes back to kpa vs kpa.

vasilis


Serial connectivity

I've got a customer with a ~10 year old laptop using native RS-232 port. This computer connects to VEMS ECU fine using 2009.06.25 vemstune, but cannot connect with current (2010.02.05). Tried with firmware versions 1.1.27 and 1.1.56

I've tweaked with baud rate, timeout, delay settings without success. Symptoms:

- Sometimes couldn't connect at all

- Sometimes connects and disconnects repeatedly at ~1-2 sec intervals

- Sometimes stays connected but gauges are jumping everywhere at high frequency (~50Hz) and always showing insane values.

/GergelyLezsak


2010.03.24

-The WBO2 calibration screen shows only 20 or 21 degrees without smaller degres, but it should show 20.8-20.9 etc..

-The saved config file name should contain the firmware version too!!!

-The sd card datalog files lenghts should show in "min:sec" format, not only in seconds format like now.

2010.04.13

-Does not load data and freezes application in 'Tune by Stats' section