GenBoard/LoggerIntegration/DedicatedLogger/WheelSpeed

Wheel Speed

Measurement of wheel slip. Requirement of at least one additional hall channel, possibly up to a total of four(including the previous speed sensor), one for each wheel.

Needs the addition of at least four additional hall / VR sensor input and conditioning. One per wheel, and possibly multiple driveshaft and gearbox speed sensors as well. Worst case scenario: Crankshaft, camshaft, front and rear driveshafts, and four wheels.

The Bunderson would ideally require two hall sensors, one front, one rear. I purposely reduced the number of hall input requirements so that the Genboard would still function as an ECU without a daughter board being created.

Fair enough. I was thinking of my own truck here, but lets keep it simple to start with.

Should we not then extend the Genboard project with a daughter board?