Oem part numbers

* Triggerwheel 030103171H

* Hallsensor 030906433Q

How to

* I chose to drill and tap the offset hole on the block. Caution it will go trough block so use Rtv on that bolt

* The block needs to be grinded down to clear the Hall sensor

* Use Rtv around the trigger flange not the usual paper gasket

* To not press the triggerwheel on to far, gently tap it on the crank and press it on with help of the flywheel. use the orange clip for TDC alignment

* Now it should be around tooth 14

* Clear and Grind down the backing plate to make it fit over trigger assembly

* It will now start if you select the default Vag 60-2 trigger Setup in Vems. fine tune from there

Oem vw crankshaft with trigger wheel is around tooth ~14

In Megasquirt around 78-84

----