History of OutputTrigger
Older Newer
2007-05-17 00:33:55 . . . . MembersPage/GaborRacz [Corrected the usage of 'mst' menucommand]
2006-02-02 17:56:16 . . . . MembersPage/MarcellGal [linked sound generator]
2005-08-16 17:19:17 . . . . MembersPage/MarcellGal [linked autronic signal generator]
2005-03-05 23:01:27 . . . . MembersPage/MarcellGal [more on testing VR with self-stim]


Changes by last author:

Changed:
* mstba (mstB9 in the prerelease firmware)
* mstB9
Changed:
* msp00, msq00 swithes the stim-output function off
* msp00, msq00 switches the stim-output function off
Changed:
* mst63 packed value: bits7:6 is the number of inserted missing teeth (range 0..3); Bits 5:0 is toothcount (range 0..63). Therefore EDIS 36-1 is 1*64 + 35 = 0x63

* mst00 swithes the stim-output function off

* mst62 packed value: bits7:6 is the number of inserted missing teeth (range 0..3); Bits 5:0 is toothcount decremented by one (range 0..63). Therefore EDIS 36-1 is 1*64 + 34 = 0x62

* mst00 switches the stim-output function off

Changed:
So mst63msp2a outputs a 36-1 triggerwheel pattern using (0x2a=42 decimal) 42*2048*36 usec crankwheel period (rather low freq. Note that board inputtrigger might not act on too low-freq signal (actual freq-threshold depending on configuration).
So mst62msp2a outputs a 36-1 triggerwheel pattern using (0x2a=42 decimal) 42*2048*36 usec crankwheel period (rather low freq. Note that board inputtrigger might not act on too low-freq signal (actual freq-threshold depending on configuration).