History of MembersPage/SuzukiValveControl
Older Newer
2011-05-19 12:18:15 . . . . 3e44be11.adsl.enternet.hu [suzuki vvt trigger]
2011-05-19 11:39:47 . . . . 3e44be11.adsl.enternet.hu [suzuki vvt trigger]
2011-04-14 20:52:23 . . . . 53d834d1.adsl.enternet.hu [factory trig is 36-2-2-2 (similar to subaru) but HALL]
2011-04-14 07:46:32 . . . . 53d834d1.adsl.enternet.hu [notes about the university setup]
2011-04-02 08:25:59 . . . . catv-89-132-137-177.catv.broadband.hu [Suzuki VVT info uploaded by FERO]
2011-03-29 23:17:19 . . . . 53d834d1.adsl.enternet.hu [file sharing link]
2011-03-29 23:14:43 . . . . 53d834d1.adsl.enternet.hu [file sharing link]
2011-03-29 22:20:55 . . . . catv-89-132-137-177.catv.broadband.hu [Suzuki engine docs by Fero]
2011-03-28 22:51:01 . . . . 53d8250f.adsl.enternet.hu [pattern information is needed]
2011-03-28 13:23:05 . . . . 53d834d1.adsl.enternet.hu [Suzuki Valve control]


Changes by last author:

Deleted:
** HALL
Added:
Secondary trigger

* Firmware support from fw 1.1.92, tested with measured triggerlogs: [vvt_off.triggerlog], [vvt_off_on_off.triggerlog]

* Use Subaru config with Special SuzukiVVT trigger enabled

* Set VVT measure pulse to 3

Tooth timing

* Triggering pulse is always at the fourth pulse after the single missing tooth if only one camsync received from the last double missing tooth

suzuki_vvt.PNG

VVT measurement

* VVT time measured from the triggering camsync pulse ( detailed in Tooth timing above)

* To the configured (Base setup menu / Secondary trigger settings dialog/ VVTI measure pulse) measure pulse after the single missing

** Recomended setting is 3