Changes by last author:
Added:
|
Wheelspeed 2 Input
What with the amazing firmware update 1.2.38 I need to consider wheelspeed 2 for traction control, I think it would be rude not to use it! Looking at InputTrigger/WheelSpeed it says to use the SCL pin on the processor. The real question is this *looking at GenBoard/VerThree/Schematic for GenBoard V3.8, it shows circuitry between JP13 SCL-in and SCL on the processor that was never there on older boards. *Is this the correct protection circuit for wheelspeed 2? **This is a sensitive connection so I need to be confident it won't end in smoke, I'm tired of that in the past. Advice welcome. I'm going to need the traction control with 250hp in a small lightweight car!! |